CK:199 Trojan
2
Noise Nuisance Recorder User Manual Guide
Page 8
Getting started
It is recommended that you connect the sound level meter to the NoiseTools software
and check that the instrument is configured as required before deployment.
See page 18 for details of the configuration options that are specific to the Trojan
2
Noise Nuisance Recorder.
Connecting the cables
The Trojan
2
is shipped with the cables connected so that it can be setup quickly and
easily.
The mains power supply and microphone cable can be disconnected from the case. This
allows the cables to be replaced if they become damaged.
To remove the cables from the case, gently pull the rubber surround upwards and away
from the case. The cable and rubber surround will slide out of the slot. To replace the
cable, gently guide the rubber surround and cable back into the slot in the case.
Connecting the microphone & preamplifier
The microphone and preamplifier are stored inside the case next to the sound level
meter. Carefully remove the microphone & preamplifier from the case and connect to
the microphone extension cable.
Take care when connecting the cable to the preamplifier. The socket and plug will only
connect in one orientation and care should be taken to ensure that the plug and socket
are correctly aligned.
Gently insert the plug into the socket ensuring that the pins are correctly aligned. Once
the plug has been pushed fully into the socket, tighten the locking ring by hand.
Take care not to over tighten the locking ring.
Mounting the microphone
The microphone and preamplifier are mounted onto a
tripod which can be positioned away from the main
case in the most appropriate location.
To mount the microphone and preamplifier to the
tripod, carefully push them through the holes on the
tripod mount.
The case has a cut out that allows the preamplifier
and the tripod mount to remain coupled when they are not being used.
