CIRRUS DESIGN CAPS, Component Manual

Page: 26 / 48

12128-001 95-01
Page 18 15 Sept 2002
2 Working from center to aft then center to forward, apply tape to cover and press
down slightly on cover while setting tape so that top surface of cover is flush with
fuselage.
WARNING: Ensure nominal bondline of 0.080 - 0.005 inch (2.03 - 0.13 mm)
3 Ensure adhesive is devoid of air pockets. Inspect bond line for voids or high spots.
Clean any adhesive that squeezes out.
(o) Through access cover CB7, remove tape and plastic sheet. Inspect and clean enclosure
for any spilled adhesive or debris.
(p) Utilizing Heated Air Cure methods, fully cure adhesive for 1 hour at 140° F (60° C). (Refer
to AMM 51-20)
(q) Fill, seal, and paint CAPS cover enclosure. (Refer to AMM 53-30)
(r) Install CAPS cover placard. (Refer to AMM 11-20)