CR-SEH
Getting Started
The CR-SEH family of wireless Ethernet modems is easy to install and operate. In most instances, the
only installation steps will be setting IP addresses, configuring one CR-SEH as the master and connecting
the antenna, power and Ethernet cable. While the operation of the CR-SEH and CR-SEHX is the same,
the installation and connection is slightly different. Please refer to the appropriate section below for
connection and installation of your product.
Setting up a pair of CR-SEHs requires the following steps:
•
Enter IP addresses into each CR-SEH
•
Configure one CR-SEH as the Master
The default settings in the CR-SEHs are sufficient to allow connection to Ethernet networks and to have
the slave CR-SEH connect with the master. Other steps you may want to take include:
•
Enter a default route IP address if data is to be sent off the CR-SEH’s subnetwork (See
Ethernet
Commands
)
•
Enable one or more of the security features of the CR-SEH (See
Security Commands
)
•
Adjust the RF bandwidth allocation (See
Radio Commands
)
•
Filter out broadcast and multicast packets (See
Bridge Commands
)
•
Change the network number (
See Radio Commands)
Instructions on setting up the CR-SEHs are detailed in the
Configuring the CR-SEH
section of this
manual. Details on the various operating modes and configurations can be found the
CR-SEH Operation
section.
2000- 2004 Cirronet
Inc
2
M-2411-0013 Rev A
