CR-SEH
CR-SEHX
Figure 3 shows the various connectors and LEDs of the CR-SEHX. Figure 4 illustrates the remote radio
assembly. Connection between the CR-SEHX enclosure and the remote radio assembly is made through
the 16-pin remote radio connector on the front of the CR-SEHX. Digital signals, rather than RF signals
are sent over the connecting cable which may be up to 300 feet in length. These cables may be ordered
from Cirronet in lengths of 100 feet to 300 feet in 100-foot increments.
Figure 3. CR-SEHX Front Panel Diagram
The remote radio assembly has mounting holes to secure the antenna. The antenna is attached to the
remote radio through the included 24-inch RF cable. If the antenna is not to be mounted on the remote
radio assembly, connection between the remote radio and the antenna must be made with high-quality ,
low-loss RF cable. Cirronet recommends limiting the length of the RF cable to 5 feet to minimize RF
signal loss.
2000- 2004 Cirronet
Inc
5
M-2411-0013 Rev A
