CR-SEH
CR-SEH Security Commands
Command Description
access help
console [enable|disable]
ip [help
add <ipaddr>
delete <ipaddr>
disable
enable
show]
show
Displays command help screen
Enables/disables password requirement for direct
console communications.
Displays command help screen
Sets IP addresses (up to 10) from which telnet
sessions will be accepted
Deletes ipaddr from list of allowed telnet initiators
Turns off telnet initiator limitation
Turns on telnet initiator limitations
Displays telnet initiator limitations settings
Displays console and IP setting
ftpw
Changes the password for FTP sessions
password <pwd>
Changes the password for telnet/console sessions
access
Group of commands that limit access to the CR-SEH through the console port and telnet
sessions. Note that there is no command to enable or disable the telnet session password. It
is always enabled.
console enable
sets the requirement that a password be entered when starting a console
connection. The password is set using the
password
command. The default setting is
disabled.
console disable
removes the password requirement.
ip enable
sets limitations set on initiating a telnet session to the CR-SEH. When enabled,
only network devices with IP addresses on the list of IP addresses added can initiate a telnet
session with the CR-SEH. Up to 10 IP addresses can be added to the list. The list is modified
with the
add
and
delete
subcommands.
ip disable
allows telnet sessions to be initiated
from any IP address (a password will still be required).
show
will display the setting of the
ip command and the list of IP addressed entered when enabled.
ftpw
This command changes the password required to initiate an FTP session with the CR-SEH.
The default password is “Cirronet” (without quotes). It is not possible to disable this
password.
password
This command changes the password required to initiate a telnet session with the CR-SEH
and initiate a serial connection through the console port when enabled. The default password
is “Cirronet” (without quotes). It is not possible to disable the password requirement for a
telnet session, but it is possible to disable the password requirement for the console
connection.
2000- 2004 Cirronet
Inc
22
M-2411-0013 Rev A
