Cirris Signature 1000R+, User Manual, Page: 29 / 88

Section 6: Retrieve a Cable from Memory / How to retrieve a cable
1000H+ User’s Guide / page 30
prompts the signature for the cable stored in permanent memory location number
1 (there can be as many as 50 of these). Continue pressing
Display/Print
until
you see the signature for the kind of cable you want to test.
4. When the display prompts the signature for the kind of cable you want to test,
release the
Memory
button.
• If the display prompts
Ready To Test
, the analyzer has retrieved the
Sample Cable data, the correct adapters are in place, and you are ready
to test cables.
• If the display prompts
JX Adapter Sig: Should Be
, this means that
the adapters you have installed don’t go with the Sample Cable you’ve
retrieved. Read the display to get the correct adapters and their
positions, then install them.
Note
: It’s OK to install adapters without
turning off the analyzer when it is in this mode. Once you’ve installed
the correct adapters, the display will prompt
Ready To Test
.
M EM LO CATIO N X
SIG :XXXXXX-XXXX
Continue to hold... ...while you step through the cable signatures
READ Y TO TEST
SIG :BBF038-0501
J1 ADA PTER SIG :
SHO ULD BE AC EFA 1
C a b le re trie ve d , a d ap te rs a re
co rre ct. You a re re a d y to te st.
Installed adapters are not correct.
Install correct adapters. When
you’ve done that, prompt will
change to
Ready to Test
.