Cirris Signature 1000R+, User Manual

Page: 17 / 88

Section 2: Check the Option Settings / What to do if you go past the value you want
1000R+ User’s Guide / page 18
• To change the option setting, press
Function
until
SAMPLE CABLE
appears, then go on to the next option by pressing
Display/Print
.
4. Continue stepping through the options by pressing
Display/Print
, changing the
settings as necessary by pressing
Function
, until all the options are set as shown
in this table: When you are done,
Ready to Learn
will appear on the display.
What to do if you go
past the value you
want
If you want to go backward through either the options or settings, press in and hold
the
Memory
button on the back of the analyzer, while pressing
Display/Print
or
Function
. Note : All options or settings will roll over to the beginning when you are
going forward or backward.
.
Your option settings
are saved
When you set the value you want, it is saved once it is displayed on the screen.Turn
off the analyzer, the analyzer will use those settings when you power it up again.
Factory Default Option Settings
Option Setting
Create Test From SAMPLE CABLE
Connection Resistance AUTO
Note: With this option set to
AUTO or CALC , the Insulation Resistance
option is not displayed and cannot be
changed The AUTO setting sets Insulation
Resistance at 5 Megohms. If you then
change the setting into the numerical
range, you will see that the setting is 5
Megohms.
Error Tones are LOW
Sorted Wire List is OFF
Count All Cables is OFF
Auto Print is OFF
Memory button