11
Figure 3 - Set Adjustment Screws, Outboard End
Measure and record distance “Y” of flange face of outboard end cover (15) to counter-bore face. Add
.009” (.23 mm) (60% of gasket (4) thickness) to this number. Make sure rotor housing (8), (10) are
seated against inboard housing adjusting screws. Measure and record distance “W” from case (1)
end flange to housing (10) end face. If housing (10) is below the case end face, add distance “W” to
the total distance “Z” + .009” (.23mm). Set adjusting screws to this distance from housing end face to
adjusting screw end face.
Summary of Contents for IMO C324AXFX-12005
Page 13: ...13...
