77
The tables below list reader settings as well as symbology settings for the CCD or Laser scan engine.
READER SETTINGS TABLE
CCD/LASER
DESCRIPTION
DEFAULT
Time-out
3 sec.
1~9 (second) for
ReaderCfg.exe
1~255 (second) for
programming
It applies to the following scan modes only:
Aiming mode
Laser mode
Auto Off mode
Auto Power Off mode
Scan Mode
Laser mode
Continuous Mode
Non-stop scanning
To decode the same barcode repeatedly, move away the scan beam and
target it at the barcode for each scanning.
Test Mode
Non-stop scanning
Capable of decoding the same barcode repeatedly
Repeat Mode
Non-stop scanning
Capable of re-transmitting barcode data if triggering within one second
after a successful decoding
Momentary Mode
Hold down the scan trigger to start with scanning.
The scanning won't stop until you release the trigger.
Alternate Mode
Press the scan trigger to start with scanning.
The scanning won't stop until you press the trigger again.
Aiming Mode
Press the scan trigger to aim at a barcode. Within one second, press the
trigger again to decode the barcode.
The scanning won't stop until (a) a barcode is decoded or (b) the
pre-set timeout expires.
Laser Mode
Hold down the scan trigger to start with scanning.
The scanning won't stop until (a) a barcode is read, (b) the preset
timeout expires, or (c) you release the trigger.
Auto Off Mode
Press the scan trigger to start with scanning.
Appendix II
CCD/LASER SCAN ENGINE
Summary of Contents for 9500PPC
