CipherLab 2564MR, User Manual

Page: 35 / 283

This chapter explains the features and usage of the barcode scanner.
IN THIS CHAPTER
1.1 Battery ..................................................................... 23
1.2 Memory .................................................................... 28
1.3 LED Indicator ............................................................ 31
1.4 Beeper ..................................................................... 33
1.5 Send “NR” to Host...................................................... 37
1.6 Scan Modes .............................................................. 38
1.7 Scanning Timeout ...................................................... 42
1.8 Delay between Re-read............................................... 43
1.9 Read Redundancy (1D) ............................................... 44
1.10 Addon Security for UPC/EAN Barcodes ........................ 44
1.11 Auto-Sense Mode ..................................................... 46
1.12 Negative Barcodes ................................................... 46
1.13 Picklist Mode ........................................................... 47
1.14 Mobile Phone/Display Mode ....................................... 47
1.15 Illumination Brightness ............................................. 48
1.16 Serial Number Stamp ............................................... 48
1.17 2D Decode Setting ................................................... 49
1.1 BATTERY
The scanner is powered by a rechargeable 3.7 V/800 mAh Li-ion battery, and it takes
approximately 5 hours to charge the battery to full (from the power adaptor). However, the
charging time may vary by working condition. For intensive data collection, you may need
a spare battery for uninterrupted operation.
Note: The scanner supports power economy. Refer to settings of “ Power Economy ”, “ Sniff
Mode ”, as well as “ Low Battery Alarm ”.
1.1.1 TURN ON/OFF THE SCANNER
Turn on the scanner…
After installing the battery, pull down the trigger for about 2 seconds. The scanner will respond with
a long beep (high tone), then the LED will become solid red and go off quickly
.
Turn off the scanner…
Remove the battery directly or let it turn off automatically in specific circumstances.
Chapter 1
UNDERSTANDING THE BARCODE SCANNER
23
Update