CipherLab 2564MR, User Manual

Page: 60 / 283

2564MR Barcode Scanner User Guide
Enable
1.15 ILLUMINATION BRIGHTNESS
Users can adjust the illumination brightness of the LED light source. Specify a value ranging
from 1 to 10 to set the brightness level which is set to 10 by default meaning 100%
illuminated.
Illumination
Brightness (1~*10)
1) Read the barcode above to commence the adjustment.
2) Read the “ Decimal Value ” barcode on page 263 for the desired illumination brightness
level.
3) Read the “Validate” barcode on the same page to complete the setting.
1.16 SERIAL NUMBER STAMP
Decide whether to add the device serial number in front of the data transmitted.
Add serial number in
front of data
*Disable
1.16.1 SEPARATOR BETWEEN SERIAL NUMBER STAMP AND DATA
Scan the barcode below to specify the separator character between device serial number
and the accompanying data. By default, the separactor is a comma symbol.
Specify the
separator character
1) Read the barcode above to specify a separator character.
2) Read the “ Hexadecimal Value ” barcode on page 264 for the desired character.
48
Enter Setup