65
GB
4. INSTRUCTIONS FOR THE END USER
The instructions contained in this section are for unqualified personnel.
4.1 INITIAL OPERATION
4.1.1 DESCRIPTION OF THE ELECTRONIC CONTROL PANEL
DISPLAY
Display parameters values, breakdowns codes and temperature
DEFROST
On for ongoing defrost / blinking for manual activation
COMPRESSOR
Lighted for active cold / blinking for delay, protection or activation blocked
DEFROST/UP
Activate defrost / go through the menu voices, increase the values
DOWN
Go through the menu voices, decreases the values
POWER
Turns ON / turns OFF
FAN
Lighted for evaporator fans in function
ALARM
Lighted for active alarm / blinking for tacit alarm
ESC
Exit function
SET
Machine status menu (short pressure), parameter programming menu ( extended pressure )
LIGHT
Turns ON and OFF cold room light
4.1.2 STARTING THE MACHINE
Press for more than 5 seconds the POWER button. A few minutes after the switch-on the compressor will begin to operate.
4.1.3 TEMPERATURE SETTING
The machine operation is fully automatic in that the manufacturer has already set the “set point” temperature (cold room tempe-
rature). To change this setting, proceed as follows:
1) PRESS
two times the SET
button: the current setting for the “set point” temperature will then be displayed.
2) SELECT
the desired temperature setting for the cold room from within the limits pre-defined by the manufacturer.
3) CHANGE
the set point setting by pressing the UP button
to increase the value and the DOWN button
to decrease it.
Once the setting has been changed press the SET button
once more.
PA
TENTE
D
Cod.30635
�
�
�
�
�
�
�
�
�
�
�
Summary of Contents for KUMA
Page 1: ...1 č ...
Page 2: ...2 ...