63
GB
3. OPERATION
3.1 DESTINED USE, INTENDED AND UNINTENDED USES
Our refrigerating equipment is classed as food and agricultural machinery (MACHINES DIRECTIVE 89/392),
destined for the treatment of food products.
MACHINE USE
The machine is designed for the conservation of foods and/or “fresh” products at temperatures indicated in Manual 2.
It has been designed to work in ambient temperatures from +16°C to +43°C (class T).
It has been designed to maintain a set temperature in a refrigerated cold room suitable for such uses.
The machine is not designed for use in cold rooms situated outside.
The machine is not designed for installation and use in an environment where there is risk of explosion.
Any use other than that permitted shall be considered improper, and in this case the Manufacturer will decline all liability.
The monobloc is not designed for the conservation of products, which produce corrosive substances.
3.2 POSSIBLE DANGER AREAS, RESIDUAL DANGERS AND RISKS,
DEVICES USED
The machines have been designed and manufactured complete with the proper devices to guarantee the health and safety of the
user.
RISKS FROM ACCIDENTAL CONTACT WITH MOVING PARTS:
The only moving parts of the machine are the fans. These fans present no risk as they are shielded by protective grids that are
fixed in place with screws. Disconnect the equipment from the power supply mains before removing these shields.
RISKS OF INSTABILITY:
The stability of the machine on the cold room is guaranteed by the proper fixing devices (supports, corner pieces).
RISKS FROM SURFACES, EDGES AND CORNERS:
The evaporator and the condenser have sharp surfaces.
“ SHARP SURFACES ”
HIGH OR LOW TEMPERATURE RISKS:
Decals have been applied in proximity to areas of high/low temperature risk. These decals are as follows :
“ EXTREME TEMPERATURES “
ELECTRICAL RISKS:
Risks of an electrical nature have been resolved during the equipment design stages, following - as far as concerns the electrical
systems - the dispositions of IEC Standard EN60204-1. Decals have been applied in proximity to those areas of electrical risk
and are as follows :
“ HIGH VOLTAGE “
CAUTION!!
It is strictly forbidden to tamper with or remove the installed safety devices (protection grids, decals.....),
and the manufacturer accepts no liability in the event of failure to observe this warning.
Summary of Contents for KUMA
Page 1: ...1 č ...
Page 2: ...2 ...