EN - 11
- Using the
+
and
–
buttons, replace this first symbol (
*
) by the first character in the code and press
OK
. Do the same for the second, third and
fourth symbols. When the last character is entered and
OK
is pressed, the following menu appears:
- To select a new access code, proceed as described above. When the last character is entered and
OK
is pressed, the screen displays the
menu below followed by the main menu.
- If you do not want to change the level 2 access code, press
ESC
to exit the new access code menu and go back to the main menu.
- If you have changed your access code but have forgotten it, you can reset it to the original code by entering the LEVEL 2 ACCESS CODE
menu and simultaneously holding down the
+
and
RESET
buttons for 10 seconds.
3.2.3 Access to level 3
A non-modifiable numeric code must be entered to access level 3:
- The following menu for entering this code appears when LEVEL 3 is selected.
- Using the
+
and
–
buttons, replace this first symbol (
*
) by the first character in the code and press
OK
. Do the same for the second, third and
fourth symbols. When the last character is entered and
OK
is pressed, the main menu appears.
3.2.4 Restricting access from level 3 to level 2
To restrict access from level 3 to level 2 only, go to the following menu
Press
Enter
. The following menu appears :
To restrict the controller to access level 2, select 'Yes' and press
OK,
.
3.2.5 Displaying the access codes on the controller after incorrectly entering the access codes:
- The digits in the access codes are replaced by the
*
symbol. When the
+
or
–
button is pressed, this symbol is replaced by the digit
0
. The
digits in the code can then be selected using the
+
and
–
buttons.
The
*
symbol appears when the digit is confirmed by pressing
OK
.
- The following message appears for 5 seconds if the access code is not entered correctly.
- When an access level is changed, the following message is displayed for 5 seconds.
3.3 Configuring access levels on the controller
- All three access levels on all the boards are accessible for a total of 20 hours of 'on' time after the controller is first turned on. During this period
any defective boards may be removed and their replacement boards configured and checked to ensure correct operation of machine.
This time period will be automatically cancelled if a user switches to level 1 or level 2 before it ends.
When the time period ends, level 2 will be authorised unless the person commissioning the system chooses to restrict access by the end user to
level 1.
- If access level 3 is authorised in order to adjust the machine parameters and, for indeterminate reasons, it is left accessible to all users, only
level 2 access will be possible after a period of 4 hours.
- Commissioning of the machine can be prohibited simply by setting parameter P99 to 'No' in level 2.
Only those with the level 2 access code may re-enable commissioning of the machine.
L E V E L 2
N E W C O D E
* * * *
L E V E L 2
N E W C O D E S A V E D
L E V E L 3
A C C E S S C O D E
* * * *
1 4 - 1 L E V E L 2 A C C E S S
L E V E L 2 A C C E S S
O N L Y
Y E S / N O
W R O N G C O D E
A C C E S S L E V E L x