1 - FOREWORD
1.1 - GENERAL INFORMATION
Installation, start-up and maintenance operations for this equipment may be dangerous if certain factors particular to this installation,
such as the presence of electrical and live components and the installation location, are not taken into account.
Only authorised, qualified installers and technicians, who have undergone specific training on the product in question, are permitted
to install and start up this equipment.
During any servicing operations, all the recommendations and instructions given in the maintenance brochures, on the labels or
in the instructions accompanying the equipment must be observed, along with any other
applicable safety instructions.
-
Observe all the regulations in the safety codes.
-
Wear safety goggles and working gloves
-
Handle heavy and bulky equipment with care when lifting, handling and setting down.
During normal use, this unit is intended to operate under the following site conditions:
-
Maximum altitude: 1000 m,
-
Minimum and maximum temperatures: -10 °C + 40 °C,
-
Overvoltage category: III
-
Pollution degree: 3
1.2 - PROTECTION AGAINST ELECTROCUTION
Only personnel qualified in accordance with the IEC (International Electrotechnical Commission) recommendations must be allowed
to access the electrical components. It is particularly recommended that all the electrical supplies to the unit are switched off before
any work is carried out. Cut the main power supply using the disconnect switch or circuit breaker.
Important: the control system includes electronic components. These may cause or be subject to electromagnetic
disturbance if they are not installed and used in accordance with these instructions.
Before carrying out any work on the frequency inverters (heat recovery wheel, etc.), disconnect the power supply
and ensure that these are not live. After disconnection, you must wait 5 minutes before starting work (necessary
for the capacitors to discharge).
Important: this equipment has been found to comply with the essential requirements of the following directives:
-
Electromagnetic compatibility: 2014/30/EU
-
Low voltage directive: 2014/35/EU
-
Machinery Directive: 2006/42/EC
-
Directive concerning the restriction of the use of hazardous substances in electrical and electronic
equipment (RoHS): 2011/65/EU
1.3 - USE
This appliance is not designed to be used by persons (including children) with limited physical, sensory or mental capabilities, or
by persons with insufficient experience or knowledge, unless they are being supervised by a person responsible for their safety or
have received instructions on the use of the appliance from such a person.
Children should be supervised to ensure that they do not play with the unit.
EN-3
FLOWAY
