HIPOT Tester 19071/19072/19073 User’s Manual
2-16
Get Cs voltage 0.016kV, Get Cs capacitance value 17.42nF, current=
0.97mA -- at the medium current range
(5) PASS Judgment
When all test steps are done and “Status Line” shows PASS, it indicates the DUT is
a good product. Then the output is cut off, rear panel outputs the PASS signal and
buzzer (short beep) in the meantime.
(6) FAIL Judgment
If the measurement is abnormal, the system will judge the DUT as a failed product
and cut off the output. The rear panel outputs FAIL signal and buzzer (long beep)
in the meantime. The action continues until [STOP] key is pressed. “Status Line”
will show fail state as below. Please see page 2-16
“Description Table for Test
Result”
.
(7) If any errors happen and cause the [START] key to be locked, you can press [STOP]
to release it.
(8) You can press [STOP] key anytime to stop the test output in any case.
Description Table for Test Result
Test Result
Meaning
PASS
Passed the tests judged as PASS product
HIGH FAIL
Measurement is over the high limit
LOW FAIL
Measurement is under the low limit
OPEN FAIL
Capacitance open/capacitance reading is lower than the setting of
OPEN.
SHORT FAIL
Capacitance short/capacitance reading is higher than the setting of
SHORT.
ARC FAIL
Current ARC is over the high limit
I/O FAIL
Hardware detects bad signal (It maybe short circuit of DUT).
NO OUTPUT
Output is not enough (It maybe the test time is not enough).
VOLT OVER
Voltage reading is over the hardware valid digits.
CURR OVER
Current reading is over the hardware valid digits.
INRUSH FAIL
Charging current is over low (It maybe test fixture bad contact).
GFI TRIPPED
Grounding failed interrupted
SLAVE FAIL
SLAVE communication fails
SKIPPED
The step is skipped. To skip the step don’t need to implement as
conducting Get Offset or Get Cs.
Cs/SHORT FAIL
The Cs is too high. To stop the detection of SHORT may be resolve
this problem.