Installation Instructions
RPMA/RPMB/RPMC Series
9
Pitch Adjustment (Vertical Elevation)
1.
Loosen PITCH adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 10)
2.
Turn PITCH micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
3.
Tighten PITCH adjustment locking screw using a #2 Phillips
screwdriver.
Figure 10
Roll Adjustment (Horizontal Tilt)
1.
Loosen ROLL adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 11)
2.
Turn ROLL micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
3.
Tighten ROLL adjustment locking screw using a #2 Phillips
screwdriver.
Figure 11
1
2
3
2
1
2
3
2
