Installation Instructions
RPMA/RPMB/RPMC Series
7
IMPORTANT ! :
When RPMX is properly positioned, the
set screw access hole should be pointing directly at
target, or 180° AWAY from target.
4.
Install four Toggler A10 Alligator concrete anchors (not
included) by inserting into pilot holes and hammering in until
flush with mounting surface.
5.
Secure RPMX to structure using four 1/4" flat washers and
four 1/4" x 3" lag bolts (not included). (See Figure 6)
Figure 6
Installing to Threaded Rod
NOTE:
The RPMX projector mount may be suspended from
four 1/4" diameter Grade 2 or better threaded rods (not
included) which are secured to unistrut, angle or
channel assembly overhead structural members
(trusses or I-beams) by Grade 2 or better 1/4-20 jam
nuts (not included).
1.
Secure one end of each of the four threaded rods (not
included) to the structural member.
2.
Install one 1/4-20 jam nut (not included) onto each threaded
rod.
3.
Install RPMX onto threaded rods, inserting the rods into the
four holes on top of the RPMX.
NOTE:
Hole in the RPMX allows socket wrench access without
unit disassembly.
4.
Secure the threaded rods to the RPMX with Grade 2 or
better 1/4-20 jam nuts (not included) and 1/4" washers (not
included). (See Figure 7)
Figure 7
5.
Proceed to
Installing Projector with Interface Bracket
section.
PROJECTOR INSTALLATION
1.
Attach projector to interface bracket using installation
instructions and hardware included with the interface
bracket.
NOTE:
Security screws can be substituted when mounting
Interface bracket to projector by using the hardware
and installation instructions in the All-Points Security
Kit (included with interface bracket).
4
x 4
5
x 4
3
1
Secure using
3
4
Secure with jam
nuts and washers
(not included)
Threaded
rods
(A)
jam nuts
(not included)
