RPMA/RPMB/RPMC Series
Installation Instructions
8
Installing Projector with Interface Bracket
1.
Orient projector with interface bracket.
2.
Lift projector so that screws with thumb nuts are aligned
with mounting slots in mount base. (See Figure 8)
3.
Slide projector with mounting bracket into mounting slots in
mount base until screws are seated against the back of
mounting slots.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
PROJECTOR FALLING RESULTING IN SERIOUS
PERSONAL INJURY OR DAMAGE TO EQUIPMENT. Make
certain mounting slots in mount base slide under thumb
screws and that screws are seated in the back of slots.
Figure 8
4.
Verify mounting screws are properly seated in mounting
slots in mount base.
5.
Move locking lever to "LOCKED" position. (See Figure 8)
6.
Insert key into lock and turn to secure projector to RPMX.
7.
Route all cables, as required.
ADJUSTMENTS
The RPMX projector mount can be adjusted for pitch (vertical
elevation), roll (horizontal tilt), and yaw (rotation).
WARNING:
OVER-LOOSENING OR REMOVAL OF
HARDWARE MAY RESULT IN PERSONAL INJURY OR
SERIOUS DAMAGE TO EQUIPMENT! RPMX projector
mount and hardware is to be loosened only enough to allow
for necessary movement.
YAW Adjustment (Rotation)
1.
Loosen YAW adjustment locking screw using a #2 Phillips
screwdriver. (See Figure 9)
2.
Turn YAW micro-adjustment screw right or left using a #2
Phillips screwdriver until image is properly aligned on target.
3.
Tighten YAW adjustment locking screw using a #2 Phillips
screwdriver.
Figure 9
2
3
(Mounting structure not shown for clarity)
(A)
[Locked]
[Unlocked]
Locking
lever
5
Lock
Mounting
slots
6
1
2
3
2
