•
Multi-Flash 3D—Display content multiple times to provide a 3D image.
Confirming the emitter setup
Define whether the 3D Sync is output and control how it is processed.
1. To set the 3D output to emitter, select MENU > Image Settings > 3D Settings > 3D Sync
Output.
2. Select To Emitter.
3. Select Enter.
4. To enable the 3D test pattern, select 3D Test Pattern.
5. Select Enter.
6. To configure the dark interval so the amount of dark time aligns with the amount of time
required for the glasses to switch, select Dark Interval.
7. Adjust the slider or enter the dark interval value as required.
8. To confirm your selection, select Enter.
9. View the displayed test pattern. If you can see both Ls and Rs with both eyes, increase the
dark interval until the Ls are only visible to the left eye and the Rs are only visible to the right
eye.
10. Optionally, to adjust the 3D Sync delay, select 3D Sync Delay.
This adjusts the timing of the sync pulse in relation to the dark time transition on the DMDs.
Use the default value of 0 as a starting point.
11. Adjust the slider or enter the delay value.
12. To confirm your selection, select Enter.
Configuring the projector for the 3D source
Configure the projector for the 3D source.
1. Select the appropriate port configuration (on page 69) and then set the inputs for your video
source (on page 70).
2. To select the correct EDID timing, select MENU > Configuration > Input Settings > EDID
Timing.
3. Select the required EDID timing and select Enter.
4. Connect all the required cables between the 3D source and the projector.
5. Configure your 3D source.
Connecting devices to the 3D sync ports
The 3D Sync Input and Output ports located on the Video Input panel provide a convenient method for
interfacing the projector to the 3D stereo projection system.
Connect the 3D Sync Input to the video source for synchronization of the left eye/right eye
frames of Direct input 3D or for frame doubled content.
The 3D Sync Input is not required for Dual-Input 3D. The 3D Sync Output is available for
control of an IR Emitter for active glasses or a polarization device for passive glasses.
3D setup
Christie M RGB Series Installation and Setup Guide
73
020-103483-04 Rev. 1 (04-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
