2. Connect the remote cable in the bottom of the remote.
3. On the projector, select MENU > Communications > Projector Communications.
4. To enable a wired version of the remote, select Wired Keypad Enabled and select Enter.
By default this feature is enabled.
Selecting a port configuration
Select a port configuration before you select a video source.
1. From the display panel, select INPUT.
2. To access the port configuration dialog from the input screen, select the right arrow.
You can also access the Port Configuration screen from MENU > Configuration > Input
Settings > Input Port Configuration.
3. From the Port Configuration screen, navigate the list of port configurations until you find the
selection that best matches your configuration.
The range of available configuration depends on the projector model and/or input/output
combinations. When the Default configuration is selected (Main Menu > Configuration >
Input Settings > Video Input configuration > Default), the following configurations are
supported:
•
One-port
•
Two-port
•
Four-port quadrants
•
One-port dual-input 3D (3D license-specific)
When SDVoE is selected (Main Menu > Configuration > Input Settings > Video Input
configuration > SDVoE), the one-port configuration is selected.
4. To return to the Input screen, select the left arrow.
Connecting devices and establishing communication
Christie M RGB Series Installation and Setup Guide
69
020-103483-04 Rev. 1 (04-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.