Section 3: Operation
3-36
Mirage S+/HD, Matrix S+/HD, Christie HD/DS/DW, DLV User’s Manual
020-100001-04 Rev. 1 (12/07)
- Software v1.6g or higher
other projectors will choose ‘To Next Input’. Choose OFF when you are not using the
Mirage
3D Stereo Sync Cable.
With your sync cable and, if desired, emitter connected as described in the
Using 3D
in Mirage
manual
, select the option suited to your 3D configuration (see above). If
Frame Delay is two (or 0), do not invert; if frame delay is one or three, invert.
Generally, an “Unlocked” setting is synchronized with the incoming L/R signal rather
than the vertical sync output, and may be needed only with multi-projector
installations in which the vertical sync outputs vary.
NOTE:
See separate
Using 3D in Mirage
manual provided for more information.
3D SYNC INPUT
—
Define which of the
Mirage 3D Stereo Sync
Cable
’
s
input connecters
is routed from your
server. Use only if the
cable is present. Only
the first projector,
possibly connected to
external sync, will choose any of these selections. Every other projector will be
getting sync from the previous projector on Input A or Input B.
3D STEREO SYNC DELAY
—
This value is set when the L/R frames begin and by
default, is automatically calculated based on signal timing; it defines the best
reference point for synchronizing the display with your glasses. Proper adjustment of
this delay should eliminate cross talk and odd colors caused by timing differences
between the glasses and the projected display. Slide bar values indicate the number of
lines that are delayed.
NOTE:
See Help menu to view the formula used to calculate
this value.
FRAME LOCK ENABLE
—
This option allows the projector to control the output frame
timing based on the input signal. The
locked
option forces (if possible) the output
image to be phase locked to the input frames.
Rate Matched
means that the output
runs at close to the input frequency but isn’t locked to it so the output will drift in
phase relative to the output. Free Run forces the output to run at a 60Hz frame rate.
NOTE:
1)
See separate
Using 3D in Mirage
manual provided for additional
information.
3D SOURCE
—
When using a Mirage projector with HD resolution, a checkbox option
called
3D Source
will be added to the bottom of the
Simulation 3D
menu. This
checkbox must be set by the user for
all new 3D sources, and cleared for all new non-
3D sources (default setting is checked). Once set, this value will be maintained for
that source for all future uses. This option is also available under the
Advanced Image
Settings
menu.
Input A
Input A, inverted
Input B
Input B, inverted
None / internal
None / internal, inverted
1.
2.
3.
4.
5.
6.
