Christie CS50-D100U, User Manual

Page: 82 / 116

MAINTENANCE AND TROUBLESHOOTING
RPMS, CS50 & CS70-D100U/UF User’s Manual
4-9
4)
INSERT NEW LAMP
: a) Hold the new replacement lamp above the lamp
compartment. Align the two holes on the lamp module with the locating pins
located on the edge of the lamp compartment. See Figure 4.5.
Figure 4.5
b) Slide the lamp all the way down until it is fully seated into the compartment.
See Figure 4.6.
Figure 4.6. Inside the Lamp Compartment
c) Tighten the two screws on the lamp module just until snug to hold it in place.
WARNING
Do not over-tighten lamp screws – it could potentially
damage the lamp module. Tighten only until snug.
5)
CLOSE LAMP DOOR
: Once the lamp is inserted, carefully close the spring-loaded
lamp door and lock it by tightening the two lamp door screws.
Watch your fingers! The lamp door is spring-
loaded and will snap close. Keep fingers clear from
the lamp compartment opening when closing the
lamp door.
6)
TURN THE PROJECTOR ON (IF APPLICABLE) OR SWITCH BACK TO THE
ORIGINAL LAMP OPERATION MODE
: Press
Power
*
to turn the projector on. If you