Christie CS50-D100U, User Manual

Page: 8 / 116

SOURCE SETUP
RPMS, CS50 & CS70-D100U/UF User’s Manual
2-5
Figure 2.7. Connecting Composite Video Sources
Connect an S-Video input to either the 4-pin mini DIN connector or the Y and C
BNC connectors provided on the video decoder module (
INPUT 4
).
NOTE: 1) Requires Optional Video Decoder module (38-804600-01). 2) Not
applicable to D100UF.
Figure 2.8. Connecting S-Video Sources
To loop a single incoming video input signal (connected at the video decoder)
through to another projector or display device, use the empty connector(s) adjacent to
this same input as described below.
Composite Video Loop Through
CONNECTIONS:
From your source, connect a composite video signal to
INPUT 3
using
either the small RCA plug or the adjacent BNC. Connect a second cable from
whichever
INPUT 3
connector is free to one of the composite video inputs of the next
display device or projector. Continue this looping method for each projector, using
either the phono-plug or the adjacent BNC as input into
INPUT 3,
then using the other
connector as an output (i.e., loop through). Whether you use the BNC or the phono
plug as input or output depends on the type of cable you have on hand and what type
of connectors are on each end.
S-Video
'
Video Loop Through
'