2-4
CP2220 Setup Guide
020-100476-05 Rev. 1 (05-2014)
dentials is prompted to press the marriage button to establish marriage. If the button is pressed any other time
it is ignored. Marriage cannot be established remotely.
•
Emergency Start:
This button is recessed into the faceplate to prevent accidental activation. It should only
be used when the TPC has failed or is disconnected. When pressed, the cinema projector is powered on, the
lamp is turned on and the douser is opened. When you press and hold this button, the douser is closed and the
lamp is turned off, but power is still on.
•
Reset:
This button is slightly recessed into the faceplate to prevent accidental activation. Its main purpose is
to reset the electronics of the cinema projector. After re-booting, the cinema projector will return to its previ-
ous power mode (Standby or Full Power), however the lamp will not strike automatically and requires man-
ual striking.
•
3D:
Connect a variety of 3D products to this connector, such as MasterImage or Real D for polarizing and
de-ghosting 3D content during projection.
ICP Faceplate Connections
The ICP board provides the image processing electronics for the cinema projector. The ICP faceplate includes
a number of LEDs that are only functional when the cinema projector is in full power mode.
•
REGEN:
(Regulators Enabled) This LED indicates the presence of the internal regulator enable signal.
When illuminated BLUE the internal regulators are enabled. When OFF, not enabled.
•
SOFTST:
(Software State) This LED indicates the state of the software application. When OFF, in a Fail
state (0). When RED, in a Fail state (1). When YELLOW, in a Fail state (2). When GREEN, status OK.
•
OSST:
(Operating System State) This LED indicates the state of the operating system. When OFF, in a Fail
state (0). When RED, in a Fail state (1), When YELLOW, in a Fail state (2). When GREEN, status OK.
•
FMTST:
(FMT FPGA State) This LED indicates the configured state of the FMT FPGA. When RED,
unable to configure FPGA with Main or Boot application. When YELLOW, in Boot application. When
Green, in Main application.
•
ICPST:
(ICP FPGA State) This LED indicates the configured state of the ICP FPGA. When RED, unable to
configure FPGA with Main or Boot application. When YELLOW, in Boot application. When Green, in Main
application.
•
Port A / Port B:
Indicates the status of the ICP input port A or B. When OFF, no source is present. When
GREEN, active source present.