6. Connect the other bare end of the protected earth wire to the building ground.
7. Connect one end of the projector power cord to the AC receptacle on the lower-left rear corner
of the projector and then connect the other end of the power cord to an AC receptacle.
8. If you are using an Uninterrupted Power Supply (UPS) to power the main electronics, move the
AC switch to A + B and connect the power cord provided with the UPS to the B outlet.
A
100-240 V secondary inlet
B
200-240 V main inlet
C
AC switch
Turning the projector on
The projector is turned on using the touch panel controller (TPC).
Warning! If not avoided, the following could result in death or serious injury.
•
SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and power range, as specified on the license label.
1. Ensure that the circuit breaker for the projector is on.
2. On the TPC, tap and hold Power On.
Logging on to the projector
Log on to the projector to access the touch panel controller (TPC) functions.
1. On the TPC, tap Menu > Login.
2. From the Username list, select a user name.
Each user account has set user access permissions.
Installing and setting up
CP2208-LP Installation and Setup Manual
19
020-102152-03 Rev. 1 (05-2017)
Copyright
©
2017 Christie Digital Systems USA Inc. All rights reserved.
