LIBERTY® Feeding System with Electronic Sensor (ES)
Feeder Line Assembly and Suspension
21
7.Slide the Drive Tube and flat washer
over the output shaft on the Power Unit,
as shown in
8.Continue installing auger until the auger
reaches the Control Unit end of the
feeder line.
9.Turn the Drive Tube Weldment into
the auger, then attach to the output
shaft of the Power Unit, as shown in
Figure 35
. Use the Driver Block to
secure the auger to the Output Shaft
10.Attach the Anchor Plate and
Gearhead Assembly to the Control
Unit Body using the included 1/4”
lock washers and 1/4-20 x 1/2” Bolts.
1523-92 4/2002
Drive Tube Weldment
Driver Block
Control Unit not
shown for clarity
1/4-20 x 1-1/2"
Socket Head Bolt
Auger
Figure 35.Auger Driver Components
Figure 36.Attaching the Anchor Plate and Gearhead Assembly to the Control Unit Body