LIBERTY® Feeding System with Electronic Sensor (ES)
Feeder Line Assembly and Suspension
19
Installing the End Control, Boot Assembly, and Auger
The End Control Unit must be at least 10 feet
[3 m]
from the end of the building to allow birds access around the
end of the feeder line.
1.Assemble the End Control Unit to the Feeder Line Control Tube using a clamp/anti-roost bracket.
See
Figure 32
.
DO NOT INSTALL THE POWER UNIT AT THIS TIME.
2.Install the Feeder Boot by sliding the straight end of the Feeder Boot into the belled end of the
Feeder Tube. Install a clamp/anti-roost bracket on the bell and tighten. The Feeder Boot must be
level with the open top of the Feeder Boot flat. See
Figure 33
.
DO NOT INSTALL THE ANCHOR BEARING AND BEARING RETAINER AT THIS
TIME
.
Auger Installation
Note:
Use extreme caution when working with the auger. The auger is under tension and may spring
causing personal injury. Wear protective clothing, gloves, and safety glasses when working with
the auger.
To avoid kinking the auger, be careful not to drop the rolled auger when handling. Inspect the auger carefully as
it is installed. Small kinks may be straightened. Large kinks must be removed and the auger brazed back together.
LIBERTY
™
ELECT.
END CONTROL GR
Figure 32.End Control Installation
END AND MID LINE CON-
TROL BOTH WILL USE
MANUAL ALL-OUT FLOOD
Feeder Tube Bell End
Feeder Boot
Anchor Bearing
Bearing Retainer
1523-90 4/2002
Figure 33.Installing the Feeder Boot
Manboot 3/98
BE CAREFUL
WHEN WORKING
WITH THE AUGER!