• When the roller and all sides and of the inlet are leveled,
firmly tight all screws with nuts to secure it in place.
The screw highligthed in green in the side picture is
needed to secure the lower metal sheet.
Place all the nuts in the closed side of the inlet.
• Insert again the square metal plate on both sides. Insert
the long screw and the washer from the inside of the
tunnel. The second whasher stays between the frame and
the inlet as a spacer while the sware plate and nut are on
the other side of the inlet. Refer to image.
Do not tighten the plate in order to be able to raise or
lower the belt conveyor system with the handwheel.
CONNECT THE OUTLET
Follow the same instruction as for the inlet. The outlet
should be easier since it is smaller and lighter.
6. INSTALLATION
Summary of Contents for 1390052
Page 8: ...3 DRAWING ACE 950 ...
Page 9: ...3 DRAWING DUAL 1200 ...
