WM110-120-130
Installation Instructions
8
Figure 7
9.
Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 8)
10. Repeat steps 7 through 9 for each mounting hole.
Figure 8
11. Place wall bracket over anchors and align mounting holes
in display mount with holes in anchors. (See Figure 9)
12. Insert 1/4-20 x 1 3/4" Phillips pan head screws (L) through
1/4" washer (N), corresponding mounting hole on wall
bracket and into anchor (M) and tighten until flush against
mount. DO NOT overtighten! (See Figure 9)
13. Repeat steps 11 through 12 for remaining 2 mounting holes.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
EQUIPMENT FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT! Overtightening of
mounting hardware can damage the steel studs. DO NOT
overtighten mounting hardware!
Figure 9
Installation to Wall Bracket
1.
Lift short throw projector arm (A) up to mounting bracket (B) and
hook top plate to upper notches on bracket. (See Figure 10)
2.
Slide lower plate into lower hooks on bracket. (See Figure 10)
Figure 10
3.
Install two 5/16-18 x 1/2" hex head cap screws (C) through
two 5/16" washers (K) and into holes on mounting bracket
and projector mount. (See Figure 11)
(M) x 3
Plastic Cap
Drywall
Anchor Metal Channel
SIDE VIEW
8
Steel Stud
Plastic Straps
Drywall
Anchor Metal Channel
Plastic Cap
SIDE VIEW
9
Steel Stud
Drywall
Anchor Metal Channel
Wall bracket
SIDE VIEW
(L) x 3
12
Steel Stud
(N) x 3
upper plate
(B)
(A)
lower plate
1
2
