background image

I N S T A L L A T I O N   I N S T R U C T I O N S

CHIEF MANUFACTURING INC.

1-800-582-6480

  952-894-6280  FAX 952-894-6918

8401 EAGLE CREEK PARKWAY, STE 700
SAVAGE, MINNESOTA 55378  USA

8832-000162

2006 Chief Manufacturing

www.chiefmfg.com

04/06

BEFORE YOU BEGIN

Top Down Desk Mount Bracket Accessory
Model: MSP-DARAC1B

Specifications:

Designed for top-down installation of KCS-110
mount.

Weight capacity of 40 lbs (18 kg).

MSP-DARAC1B

(Shown installed on KCS-110, purchased separately)

WARNING:

It is the installer’s responsibility to make sure all components are properly assembled and installed

using the instructions provided.  Failure to read, thoroughly understand, and follow all instructions can result in
serious personal injury, damage to equipment, or voiding of factory warranty.

If you have any questions about this these instructions or your specific installation, contact Chief Manufacturing
at 1-800-582-6480 or 952-894-6280.

Summary of Contents for MSP-DARAC1B

Page 1: ...ion of KCS 110 mount Weight capacity of 40 lbs 18 kg MSP DARAC1B Shown installed on KCS 110 purchased separately WARNING It is the installer s responsibility to make sure all components are properly assembled and installed using the instructions provided Failure to read thoroughly understand and follow all instructions can result in serious personal injury damage to equipment or voiding of factory...

Page 2: ...aller s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment Reinforce the structure as required before installing the component WARNING Exceeding the weight capacity can result in serious personal injury or damage to equipment It is the installer s responsibility to make sure the combined weight of all components...

Page 3: ...splay See instructions included with desk mount 2 If previously attached loosen clamp attach screw See Figure 2 Remove desk mount from desk Figure 2 Remove Desk Mount 3 Using 2 5mm hex key remove base plate and attach screws from desk mount housing See Figure 3 NOTE Base plate and attach screws will not be reused in MSP DARAC1B installation Figure 3 Remove Base Plate Table 1 Parts Item Description...

Page 4: ...ket 10 as a template mark location of three pilot holes 3 Drill three 1 8 diameter pilot holes in mounting structure at locations marked in previous step See Figure 6 Ensure pilot holes are straight Figure 6 Install Mount IMPORTANT IF you will be installing a display with RECESSED mounting holes then install display to mount before continuing with this mount installation procedure Proceed to DISPL...

Reviews: