background image

Installation Instructions

2

 IMPORTANT WARNINGS AND CAUTIONS!

WARNING:

 A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions.

CAUTION:

 A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the

corresponding instructions.

WARNING:

Failure to provide adequate structural strength for this component can result in serious personal injury

or damage to equipment!  It is the installer’s responsibility to make sure the structure to which this component is
attached can support five times the combined weight of all equipment.  Reinforce the structure as required before
installing the component.

WARNING:

Exceeding the weight capacity can result in serious personal injury or damage to equipment!  It is the

installer’s responsibility to make sure the combined weight of all components attached to the MSP-DARAC1B
(including the mount and display) does not exceed 40 lbs (18 kg).

CAUTION:

Overtightening fasteners may result in improper operation, excessive wear or damage to equipment,

and/or voiding of factory warranty!

DIMENSIONS (AS INSTALLED ON KCS-110)

Summary of Contents for MSP-DARAC1B

Page 1: ...ion of KCS 110 mount Weight capacity of 40 lbs 18 kg MSP DARAC1B Shown installed on KCS 110 purchased separately WARNING It is the installer s responsibility to make sure all components are properly assembled and installed using the instructions provided Failure to read thoroughly understand and follow all instructions can result in serious personal injury damage to equipment or voiding of factory...

Page 2: ...aller s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment Reinforce the structure as required before installing the component WARNING Exceeding the weight capacity can result in serious personal injury or damage to equipment It is the installer s responsibility to make sure the combined weight of all components...

Page 3: ...splay See instructions included with desk mount 2 If previously attached loosen clamp attach screw See Figure 2 Remove desk mount from desk Figure 2 Remove Desk Mount 3 Using 2 5mm hex key remove base plate and attach screws from desk mount housing See Figure 3 NOTE Base plate and attach screws will not be reused in MSP DARAC1B installation Figure 3 Remove Base Plate Table 1 Parts Item Description...

Page 4: ...ket 10 as a template mark location of three pilot holes 3 Drill three 1 8 diameter pilot holes in mounting structure at locations marked in previous step See Figure 6 Ensure pilot holes are straight Figure 6 Install Mount IMPORTANT IF you will be installing a display with RECESSED mounting holes then install display to mount before continuing with this mount installation procedure Proceed to DISPL...

Reviews: