StagePRO
KBDS
‐
01D
DJ
Stand
Assembly
Instructions
Parts
List
1
2
Feet
2
1
Leg
#2
3
1
Leg
#3
4
2
Adjustable
Cross
Members
5
1
Upper
Support
Bracket
#5
6
1
Upper
Support
Bracket
#6
7
1
Expandable
Table
8
1
Velcro
Safety
Strap
9
2
Optional
Mounting
Clamps
10
Hardware
A
4
Cross
Members
Tensioning
Knobs
B
2
Expandable
Table
Tensioning
Knobs
C
2
Wing
Nuts
for
Expandable
Table
Tensioning
Knobs
D
4
Screws
with
Plastic
Washers
(quantity
shipped
may
vary)
E
Foam
Cushions
Required
Tools
1
Phillips
Screw
Driver
Step
1
Place
Feet
on
flat
surface
with
raised
section
facing
up.
Place
slots
in
short
angled
section
of
Leg
#2
over
holes
in
Foot.
Long
section
of
Leg
#2
should
be
pointing
up
with
flat
surface
to
the
outside.
Place
2
Plastic
Washers
on
2
Screws
and
insert
Screws
through
slots
on
Leg
#2
and
into
holes
on
Foot.
The
ends
of
the
Foot
and
Leg
#2
should
be
flush.
Tighten
screws
Repeat
process
for
second
Foot
and
Leg
#3.
Step
2
Place
assemblies
in
front
of
you
so
the
long
sections
of
the
Feet
are
facing
away
and
the
back
of
the
DJ
Stand
is
facing
you.
The
long
flat
sections
of
the
Legs
#2
and
#3
should
be
to
the
outside.
Ensure
both
Cross
Members
are
adjusted
to
the
same
length.
Place
threaded
ends
of
one
Adjustable
Cross
Member
in
center
notch
of
each
Leg.
Attach
and
tighten
a
Cross
Member
Tensioning
Knob
to
the
Leg
on
left
side
(this
will
provide
stability
for
assembly
and
will
be
removed
in
a
later
step).