10
Installation Instructions
FWD-111
CABLE MANAGEMENT
WARNING: Make sure your cables do not run through a
pinch point.
1.
Connect and secure power/audio/video cables, making
sure to leave sufficient slack to allow for movement of the
display.
2.
Route power/audio/video cables under each arm, allowing
sufficient slack in cables for extension and avoiding pinch
points
3.
Secure cables using cover plates (130) and four screws
(140).
ADJUSTMENTS
CAUTION: Overtightening adjustment will cause
excessive wear.
Rotational Tilt, Pitch, and Roll Adjustment
1.
Test the Centris adjustment by tilting, pitching, and rolling
the Centris mount interface (see Figure 12).
2.
If necessary, remove display from the mount.
3.
Use a Phillips screwdriver to tighten or loosen the Centris
adjustment screw.
4.
Check for desired tension.
5.
Repeat the procedure until desired tension is obtained.
Lateral Tension Adjustment
1.
Using a 3/16” hex wrench (150), slightly tighten or loosen
lateral tension adjustment bolt (see Figure 13).
2.
Check for desired tension.
3.
Repeat Steps 1 and 2 until desired tension is obtained.
Figure 12. Adjust Centris Adjustment Screw
Lateral Tension Adjustment Bolts
Figure 13. Lateral Tension Adjustment
