Installation Instructions
FCA800V/VE
9
7.
(For
minimum/intermediate extension
) Use two #10-24
lock nuts (J) to secure upright bracket (A) to main bracket
(B) and adapter plate (V). (See Figure 8)
NOTE:
Minimum configuration is shown below. Intermediate
configuration is possible depending on which holes are
used.
8.
(For
minimum/intermediate extension)
Use 1/4-20 x 5/8”
hex head flange bolt (M) and center washer (H) to secure
upright bracket (A) to main bracket (B). (See Figure 8)
Figure 8
Attaching Accessory to Cart/Ceiling Mount
IMPORTANT ! :
If installing to a 2x1 display cart using
the FCA623 accessory, proceed to “Installing to FCA623
Accessory” Section (Step 6).
1.
Use two 1/4-20 x 1/4” button head cap screws (R) and two
large washers (P) to secure support bracket (C) to main
bracket (B). (See Figure 9)
2.
Slide main bracket (B) onto front of cart/ceiling mount head
assembly until support bracket (C) rests on top of head
assembly. (See Figure 9)
Figure 9
3.
Slide second support bracket (C) underneath cart/ceiling
mount head assembly, lining up holes on support bracket
(C) to holes on main bracket (B). (See Figure 10)
4.
Use two 1/4-20 x 1/4” button head cap screws (R) and two
large washers (P) to secure support bracket (C) to main
bracket (B). (See Figure 10)
Figure 10
5.
Proceed to Step 11.
(J) x 2
7
(B)
(A)
(M)
8
(Below wall - minimum)
(V)
(H)
holes to
use for intermediate
configuration
(rear view)
(C)
2
(R) x 2
1
(P) x 2
(B)
(Below cart/ceiling - Standard)
(rear view)
(C)
(R) x 2
4
(P) x 2
3
(B)
(Below cart/ceiling - Standard)
