TIL1X2AA / TIL1X3AA / TIL1X4AA / TILVABAA
Installation Instructions
10
Installing Housings and LED Screens
IMPORTANT ! :
Reference the LEDs installation manual
for specific instructions regarding care, handling, cabling
and installation of the LED housings and modules.
NOTE:
Begin the installation of the housings in the lower left
corner of the video wall.
NOTE:
One complete column of housings should be installed
before proceeding to the next column.
1.
Install the first LED housing in the lowest left-hand corner of
the video wall by aligning mounting buttons on the housing
with the mounting holes on the wall mount.
2.
Move LED housing forward until all four mounting buttons
are through mounting holes in wall mount.
3.
Lower housing until contacting the bottom of mounting
holes. (See Figure 16)
Figure 16
4.
Continue with the next housing (directly above installed
housing).
NOTE:
Be sure to check the level and plumb of the housings
occasionally during the housing installation.
5.
AFTER
the
entire
first column of housings are installed,
slide the column to the left side so that the mounting buttons
are against the tapping screws, and to allow clearance for
installation of the second column.
6.
After the second column is installed, push to the left until the
first and second columns of housings are touching.
7.
Repeat until all housings are installed.
8.
Install two 10-24 x 1-1/2" Phillips head cap screws (D)
per
housing
on far right column of mounts. (See Figure 17)
NOTE:
The screws (D) are installed from the right side of the
furthest right wall mount and can be used to push the
housings to the left and to prevent removal of the LED
modules. The screws can also be used to slightly level
or align the housings by adjusting the amount of push
at the bottom or top of the housing.
Figure 17
9.
Using levels, check the level and plumb of the housings
installed on the mounts and adjust as necessary following
information in the
Adjustments
section.
10.
Only AFTER the housings have been adjusted as
necessary and are in the final, required position
cam
housings together following instructions included with
LEDs.
11. Install LED modules following instructions included with
LEDs.
2
LED Housing
[TIL1X2AA shown as example]
Front view
Back
view
8
(D) x 2
[per module]
