20
Machine Maintenance (cont.)
Refill Hydraulic Fluid Reservoir
The hydraulic pump reservoir contains 12 quarts (13 liters) of
hydraulic oil. When refilling or adding oil, fill to within 1/2” (12mm)
of fill port using SUS 215 viscosity @ 100°F (38°C) 10W Hydraulic
Oil, Figure 39.
Caution:
1. Fill pump reservoir with all cylinders retracted and
deck at lowest working height.
2. DO NOT overfill pump reservoir.
LIft & Port-a-frame Assembly
All lift leg and porta-frame pivot points are permanently lubricated
and do not require maintenance except for
occasional cleaning.
Outer Track
Using compressed air, blow dirt and debris from outer track. If
necessay, use stiff brush to remove build-up of dust and paint on
outer track surface.
Visually inspect outer track for damage. Although small dents
or upsets in the outer track may not affect the operation of the
tower, they might indicate tower adjust¬ment is necessary.
Sure-Lock
With normal use, the pivots on the Sure-Lock clamping system
should stay free of dirt and operate smoothly and quietly. Ex-
tended periods of non-use or damp environments may adversely
affect the operation of the Sure-Lock.
Use compressed air to blow dirt and debris from Sure-Lock pivot
points. Apply a few drops of oil to Sure-Lock pivot pin and handle
shaft pivots and work mechanism.
NOTE:
It may be necessary to remove the handle shaft retainer
bolt and washer to lubricate both sides of the handle
shaft. Refer to Parts Manual exploded view for details
on removal of handle shaft retainer components.
Caution:
Wear safety glasses while using compressed
air to blow out dirt and dust.
The rotational motion of the Sure-Lock handles is transmitted to
the Sure-Lock linkage via a 1/4” key. The key is retained by a 1/4-
20 bolt. Verify that the bolt is tightened correctly.
Visually inspect the internal Sure-Lock linkage to verify that the
Tower Linkage Driver bar is centered on the Sure-Lock handle
shaft. With the Sure-Lock clamp in the locked posi¬tion, inspect
the engagement of the tower float linkage bars to the handle
shaft.
Tower Rollers
Using compressed air, blow dirt and debirs from the tower outside
wheel assemblies. Visually inspect the bolts retaining the outside
wheels to the tower weldment and the outside roller guard for
damage.
Verify that the four bolts retaining the tower hook to the inside end
of the 360 tower are not loose. Verfiy that the two bolts holding the
tower outrigger block are tight.
NOTE:
Refer to Parts Manual for detailed exploded views of
referenced parts. Contact Chief Collision Technology
with any questions regarding the usage or maintenance
of the PHOENIX system.
Reservoir Fill - Clean
Area Before Removing
Breather Cap
Figure 39
PHOENIX
USERS MANUAL