SKU 99630
For technical questions, please call 1-800-444-3353.
Page 7
mOunTIng
note:
The Hoist is delivered completely
assembled. It must only be mounted
for use.
The hoist may be mounted on a fixed
overhead pipe, or attached to a pole on a
rotating pillar.
To attach your hoist to an overhead
pipe using the included brackets.
Find the 2 Fixing Rings (4) and the 4
1.
Hex Head Bolts (1).
Place the Fixing Rings (4) over a suit-
2.
able pipe, in the position you wish to
mount the hoist. See Figure 1 below.
Have an assistant hold the hoist
3.
in place while you install the Bolts
through the Fixing Rings into the
threaded holes in the Hoist Body (6).
See Figure 1.
4.
With the hoist in the correct position,
firmly tighten the bolts. See Figure 1
below as well as the Parts List and
Assembly Diagram on pages 9 and
10.
5.
WaRnIng!
Make sure the mount-
ing surface is capable of holding the
electric hoist in addition to the maxi-
mum lifting load of 220 Lbs.
OpERaTIng InsTRuCTIOns
The cable spool will not turn freely.
1.
To pull out or wind up cable, you must
operate the power switch.
To operate the power switch, take the
2.
control handle in your hand. Press
the upper part of the rocker switch to
reel in the cable. Press the lower part
of the rocker cable to reel out cable.
Check to be sure it is safe to lift the
3.
item.
To pull out the cable, grasp the lift
4.
hook, and pull it away from the hoist
while pressing the lower part of the
power switch . Always leave at least
three turns of cable on the spool to
prevent pulling the cable out of the
hoist spool.
Attach the cable firmly to the item
5.
using the lift hook or pulley lift hook.
See Figures 2 and 3 on pages 8.
6.
WaRnIng!
Make sure the safety
clasp on the hook is fully closed to
prevent the load from slipping off the
hook.
7.
WaRnIng!
Never wrap the cable
around the object and hook onto the
cable itself. This can cause damage
to the object being pulled, and kink or
fray the cable.
Stand clear, and when it is safe to do
8.
so, use the power switch in the con-
trol handle to retract the cable, and
hoist the item as desired.
Read the EnTIRE ImpOR-
TanT saFETY InFORma-
TIOn section at the begin-
ning of this manual subhead-
ings therein before set up or
use of this product.
(4)
(6)
(1)
FIguRE 1
