ENGLISH
64 - Vers. 04/2019 Cod. 9828093300 00 -
24.0 GRAPHIC CONTROLLER; ELECTRIC MOTOR BEARINGS GREASING (For variable speed only)
BEFORE PERFORMING ANY TYPE OF SERVICING, THE MACHINE MUST BE SHUT DOWN AND ISOLATED FROM THE
MAINS POWER AND COMPRESSED AIR DISTRIBUTION NETWORK, AND CHECK THAT THE MACHINE IS NOT UNDER
PRESSURE.
- Remove the panel (fixed protection) Ref. 1 Fig. 29
- Remove the grease nipples Ref. 2 and 3 Fig. 29
- Screw the grease tube onto the motor thread.
- Inject the contents of the two tubes for each bearing and screw the grease nipples back on.
- Close the panel (fixed protection) Ref. 1 Fig. 29
Proceed as follows:
- Restore the power supply
- Activate the lubrication programme from the MK5
menu:
- Select the lubrication function (password
1807
)
.
- Go back to the main menu and press
“START” (
Ref. 4 Fig. 29)
.
-
The compressor will run the lubrication programme: in unloading mode for
(15 minutes at 1700 rpm).
- From the lubrication menu, the operator can check the remaining time.
N.B. During lubrication, it is not possible to stop the machine using the
STOP key Ref.
(5 Fig. 29).
In any case, in the event of an
EMERGENCY
the operator can stop the compressor by pressing the emergency button.
Once normal conditions are restored by pressing
START (
Ref. 4
Fig. 29) the compressor will resume lubrication for the remaining time.
At the end of the lubrication cycle, the standard operating conditions will therefore be automatically restored.
