SKU 95596
For technical questions, please call 1-800-444-3353
PAGE 5
NOTE:
16.
When using cables to power
the inverter, keep the cable length
to a minimum. The shorter the cable
the less voltage drop will occur. Low
voltage to the inverter will sound an
alarm and shut off the inverter.
People with pacemakers should
17.
consult their physician(s) before
using this product. Electromagnetic
fields in close proximity to a heart
pacemaker could cause interfer-
ence to or failure of the pacemaker.
The warnings and cautions dis-
18.
cussed in this manual cannot cover
all possible conditions and situa-
tions that may occur. It must be
understood by the operator that
common sense and caution are fac-
tors which cannot be built into this
product, but must be supplied by
the operator.
SAVE THESE INSTRucTIONS
gROuNdINg
WARNINg!
Improperly connecting the grounding
wire can result in the risk of electric
shock. Check with a qualified electri
-
cian if you are in doubt as to whether
the outlet is properly grounded. do not
modify the power cord plug provided with
the tool. Never remove the grounding
prong from the plug. do not use the tool
if the power cord or plug is damaged. If
damaged, have it repaired by a service
facility before use. If the plug will not fit
the outlet, have a proper outlet installed
by a qualified electrician.
gROuNdEd TOOlS: TOOlS
WITH THREE pRONg plugS
Tools and appliances marked with
1.
“Grounding Required” have a three
wire cord and three prong ground-
ing plug. The plug must be con-
nected properly to the grounded
outlet of the Inverter. If the tool or
appliance should electrically mal-
function or break down, grounding
provides a low resistance path to
carry electricity away from the user,
reducing the risk of electric shock.
The grounding prong in the plug
2.
is connected through the green
wire inside the cord to the ground-
ing system in the tool or appliance.
The green wire in the cord must be
the only wire connected to the tool
or appliance grounding system and
must never be attached to an elec-
trically “live” terminal.
dOuBlE INSulATEd TOOlS:
TOOlS WITH TWO pRONg
plugS
Tools marked “Double Insulated” do
not require grounding. They have
a special double insulation system
which satisfies OSHA requirements
and complies with the applicable
standards of Underwriters Labora
-
tories, Inc., the Canadian Standard
Association, and the National Elec-
trical Code.
REV 08g, 09d
