Page 10
For technical questions, please call 1-888-866-5797.
Item 62811
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Make sure that the power Switch is in the OFF (O) position and the tool is unplugged
from its electrical outlet before performing any procedure in this section.
Before First Use, After Long-Term Storage And When Operating In cold Temperatures
Distribute internal lubricant:
1. Lay Breaker Hammer on its side on a
surface that will withstand vibration.
cAUTION!
Do not install chisel for this operation.
2. Make sure that the Power Switch is in
the OFF (O) position, then plug Breaker
Hammer into dedicated 120V outlet.
3. Press the Power Switch to ON (I) position and
let Breaker Hammer run for several minutes.
4. When done, Press the Power Switch to OFF (O)
position, then unplug Breaker Hammer.
Installing Non-collared chisel (Included)
Note:
Keep shank clean. Do not lay in dirt or dust.
1.
IMpORTANT!
Clean shank with cloth, then
lubricate using included Chisel Grease.
Note:
Chisel must be installed with Notch facing up.
Notch
Shank
2. Move Chisel Lock to unlocked position.
3. Slide Chisel in as far as it will go
with Notch facing up.
chisel
Lock
chisel
Figure B: Unlocked position
4. Move Chisel Lock to locked position.
Note:
Chisel Lock will not lie flat against the chuck.
Figure c: Locked position
Note:
The Chisel will have play, but
should not come out when pulled.
