Page 12
For technical questions, please call 1-888-866-5797.
Item 62811
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Maintenance and Servicing
procedures not specifically explained in this manual must be
performed only by a qualified technician.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Make sure that the power Switch is in the off-position and unplug the tool from
its electrical outlet before performing any procedure in this section.
TO pREVENT SERIOUS INJURy FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
cleaning and Maintenance
1.
BEFORE EAcH USE,
inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• damaged cord/electrical wiring,
• dull or cracked Chisel,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
2.
AFTER USE,
wipe external surfaces
of the tool with clean cloth. Do not use
solvents, only use soap and water.
Note:
Store where temperature is no lower than 50° F.
3.
WARNING! If the supply cord of this
power tool is damaged, it must be replaced
only by a qualified service technician.
carbon Brush Replacement and Lubrication
If the Carbon Brush Light comes on and Breaker Hammer stops operating, have a qualified technician:
1. Replace Carbon Brushes.
2. Refill internal lubricants.
