Chelsio Communications Chelsio T4, Installation And User Manual

Page: 118 / 511

Chapter VII. iSCSI PDU Offload Target
Chelsio T5/T4 Unified Wire for Linux
Page 118
Yes: ACL is enforced on the target
No: ACL is not enforced on the target
NOTE : ACL flag is not allowed to be
updated on the fly. Target must be
restarted for new ACL flag to take
effect.
ACL [iname=<name1
>][;<sip=<sip
1>][;dip=<dip
1>][;lun=<lun
_list:permiss
ions>]
Yes The ACL specifies which initiators and
how they are allowed to access the
LUNs on the target.
iname=<Initiator Name> specifies
one or more initiator names, the name
must be a fully qualified iSCSI initiator
name.
sip=<Source IP address> specifies
one or more IP addresses the initiators
are connecting from.
Dip=<Destination IP address>
specifies one or more IP addresses
that the iSCSI target is listening on
(i.e., the target portal IP addresses).
NOTE: when configuring an ACL at
least one of the above three must be
provided:

iname, and/or

sip, and/or

dip.
lun=<lun list>:<permission> controls
how the initiators access the luns.
The supported value for
<lun list> is
ALL .
<permissions> can be:
R : Read Only
RW or WR : Read and Write
If permissions are specified then the
associated LUN list is required.
If no
lun=<lun list>:[R|RW] is
specified then it defaults to ALL:RW .
NOTE: For the Chelsio Target
Software release with lun-masking
included,
<lun list> is in the format of <0..N |
0~N | ALL>
Where:
0..N : only one value from 0 through N
0~N : a range of values between 0
through N
ALL : all currently supported LUNs.
Multiple lists of LUN numbers are
allowed. When specifying the list
separate the LUN ranges by a comma.
RegisteriSNS “Yes”
“No”
“Yes”
No To turn on or off exporting of target
information via iSNS