Chef CKG5010W, Instruction Book

Page: 8 / 40

8
Location
Qualified tradespersons must
carry out installation work on the
cooker. The cooker is heavy.
Certain edges and corners, which
will not normally be exposed, may
be sharp. USE GLOVES when
moving the cooker.
Before installing the cooker, you
should check that its dimensions
correspond to the rest of your kitchen
units. Measure the height of the
worktop from floor to top surface of
the worktop, and the cooker depth
from the wall to the front edge of the
cooker (see picture). The cooker
must also be installed in conformity
with the following standards.
If a 10A power socket or hard wiring
is required for installation, a licenced
electrician must install it.
Carry out installation as
described in the Installation
Requirement chapter – paragraph
2.4 of AG101-2000.
Gas installation must be carried out by
a qualified gas fitter in accordance with
AG101-2000. Choose a location free of
draughts and open doors and clear of
combustible materials or other fire
hazards such as curtains, etc.
The location should ensure
convenience of operation and service.
Any adjacent cabinets or walls must
not exceed the cooker’s sides height
(see fig.).
The cooker may be located in a
kitchen or dining room, but not in a
bathroom or shower room. The
levelling feet fitted to the appliance
can be adjusted to achieve a nominal
height to hotplate of 900mm + 10mm.
min
600
max
400
min
570
6
90
50
0
150
The cooker should be
installed only on the floor, it is
not suitable for installation on a
base.