UN41-401FL
D
A
E
C
B
UN41-0405ML
B
A
English language
Use and maintenance
23
ADJUSTMENT INFORMATION
5
Adjusting the dispensing/ejection timing
When the plant falls into the ploughshare (
C
), the ejector
(
B
) should be in the rear position and should then start
pushing the plant to eject it.
If the conditions allow high- or low-speed planting, cor-
rect timing between the dispenser and the ejector can
be maintained by adjusting the dispenser.
For adjustments, proceed as outlined below.
1) Remove the pin (
A
).
2) Remove the lid (
D
).
3) Loosen the screws (
E
).
4) Turn the dispenser clockwise to speed up the ejec-
tor’s pushing action or rotate the dispenser anticlock-
wise to delay the pushing action.
The notches on the dispenser allow accurate timing
adjustment.
5) Tighten the screws (
E
).
6) Place the lid (
D
) on the dispensing unit.
7) Insert the pin (
A
).
Adjusting the planting unit load
The weight (load) to be applied to the packing wheels is
obtained by the combined action of the handwheel (
A
)
and nut (
B
).
For adjustments, proceed as outlined below.
Alternatively turn the handwheel (
A
) clockwise or anti-
clockwise and tighten or loosen the nut (
B
) to exercise
the ideal weight on the packing wheels.
