-
MAX
: displays the max of the current RMS or PEAK value, or the frequency
-
MIN
: display of the min of the current RMS value, or the frequency
-
AVG
: display of the true average since the beginning of the recording (RECORD)
- SMOOTH : filtered measurement ; average of the digital value over 3 seconds
-
RANGE
: indicates manual range selection
-
P
: indicates permanent operation; Auto Off after 10 minutes is cancelled
-
: low battery warning symbol
-
: warning light "refer to User manual". This light is activated above 600V RMS,
1000V peak or 1000A peak.
VOLTAGE INPUT AND ANALOGUE OUTPUT
9
Two safety sockets
These sockets of diameter 4mm and centre to centre gap of 19mm receive the leads in
order to:
- measure the voltage; use the set of leads with prods,
- display the waveform of the current on an oscilloscope or a recorder, on the analogue
output Vout (1mV/A or 10mV/A); use the lead with BNC/banana safety plugs.
SOUND SIGNALS
The clamp is equipped with a buzzer that emits different types of sound signals at three
emission frequencies and for three different durations.
NB : A warning signal consists of 2 short beeps at high frequency and the symbol
is displayed.
OPERATING PROCEDURES
SWITCHING ON : current or voltage measurements
By selecting the main function A AC or V AC with the switch, the clamp switches On ; all the
symbols appear for approx. 0.5 seconds on the display.
Enclose the clamp around the conductor or connect up and read the true rms value of the
current or voltage.
NB : Pressing one of the function buttons, when switching On, makes all the symbols appear
on the display.
This set of symbols remains as long as the button is pressed: the battery can be checked
in this way.
OFF: MANUAL OFF
Resetting to the OFF position switches Off the clamp and the configuration that may have
been programmed is lost.
AUTO OFF
The clamp switches Off automatically after 10 minutes of operation in the following con-
ditions:
- the buttons have not been pressed,
- the switch has not been turned,
- permanent operation is inactive.
The purpose of this function is to economise the power of the battery, if you forget to reset
to the OFF position after taking measurements.
The clamp emits a short beep at average frequency before "going to sleep".
Press any button and the clamp "wakes up" in the previously selected configuration ; the
function of this "wake up" button is thus not taken into account.
The switch also allows you to "wake up" the clamp, but it manages the main functions so if
the switch is turned the previous configuration is lost and in particular the RECORD mode.
31
32
SOUND
LOW
AVERAGE
HIGH
SIGNAL
FREQUENCY
FREQUENCY
FREQUENCY
short : 63ms
_
button On
. button Off
. range overload
. warning
average: 126ms
MIN detected
MAX detected or
_
PEAK detected
long: 252ms
Output of RANGE
and RECORD modes
_
_
(press button
and hold)
www.motralec.com / [email protected] / 01.39.97.65.10