44
2. Printing documents (doc)
Measurements that have not yet been saved or
saved measurements can be printed out one after
the other on a serial RS232 printer in A6 format, or
on parallel A4 printers via an optional “serial-to-
parallel” adapter.
6.3.1 Preparing the printout
The settings below, defined in the SET-UP menu, are used to configure the default printing parameters.
1. Switch on the instrument or turn the selector switch.
2.
Press the “PRINT / SET UP” button for over 2 secs.
All the segments of the LCD are displayed (Display Test) = 1
st
screen in SET-UP mode.
3. Press the “MORE” button as many times as necessary until “bd” (baud rate) is displayed. With the
SELECT and CHANGE buttons, choose the speed of the RS232 interface by changing the “baud
rate (bd)” between 300 bauds and 9.6 k bauds.
If using a parallel A4 printer and therefore the serial-to-parallel adapter, then you must choose “- - -”
as the interface speed.
4. Press the “MORE” button again, so that “prt” is displayed.
Use the following buttons:
“SELECT” – To make the print format (A4 / A6) or the type of printout (“prt” OR “doc”) flash
“CHANGE” – To choose the A4 or A6 print format and the Protocol (prt ) or Document (doc)
type of printout.
Note that with the A6 format, only the “Documents” type printout is available.
5. To quit “SET UP” and store the changes made, press “MORE” until you have worked through all of
SET-UP, or press “TEST”. If you turn the selector switch, the changed settings will not be saved after
the instrument is switched off.
Printing can be done in 10 different languages (French, English, German, Italian, Spanish, Swedish,
Norwegian, Lithuanian, Dutch and Czech). The optional PC software needs to be used in order to
change the default language: English.
6.3.2 Immediate printing of unsaved measurements (doc)
This function is used to print out the displayed value immediately, in the “doc” form. (measurement with
the date and time etc…).
1. Connect the instrument to the printer with the appropriate cable (see chapter 6.1). Do not
switch on the serial printer before having first of all switched on the instrument. Otherwise,
“ ?” signs are printed indefinitely.
2. Perform the required measurement.
3. When the measurement is displayed, press the “PRINT” button.
4. Printing begins.
If the printing is being done on a parallel A4 printer via an optional serial-to-parallel adapter,
first of all select the A4 format and set the baud rate to = “- - -” in “SET UP”!
Once the print out is finished, you can save the measurement with “MEM/MR”.
To begin a new measurement, press the “TEST” button.
To go back to the display of the network voltage U
L-N
, turn the selector switch or press CHANGE or
SELECT.
Summary of Contents for C.A 6115N
Page 1: ...1 E N G L I S H User s manual INSTALLATIONTESTER C A6115N...
Page 53: ...53...
Page 54: ...54...
Page 55: ...55...
