5
3. Lamp
∞
Lamp :
ELC3 24V 250W (300 Hrs)
1. Always switch off the main supply and never handle the lamp or luminaries when is hot.
2. Do not touch the bulb with bare hands. If this happens, clean the lamp with denatured alcohol and wipe it
with a lint free cloth before installation.
3. Never operate the lamp without appropriate shielding.
4. Make sure the lamp is located in the center for the best spot.
Diagram for Lamp changing
4. How To Set The Unit
4.1 Control Panel
MODE
DOWN
UP
ENTER
SOUND
SLAVE
MIC
MIN MAX.
CONTROL (CA-6)
ONLY FOR REMOTE
SENSITIVITY
DMX
MASTER
DMX OUT
DMX IN
1. Display
To shows the various menu and the selected functions.
2. LED
DMX
On
DMX input present
MASTER
On
master mode
SLAVE
On
slave mode
SOUND
Flashing
sound activation
3. Button
MENU
to select the programming functions
DOWN
to go backward in the selected functions
UP
to go forward in the selected functions
ENTER
to confirm the selected functions
4. Remote controller input
By connect to the 1/4” microphone jack to control the unit for Stand by, Strobe/Next and
Fast/Slow function.
5. Sensitivity
To adjust the microphone-receiving sensitivity.
6. Microphone
To receives audio signal for sound activation.
7. DMX input/output
For DMX512 link, use 3-pin XLR plug cable to link the unit together.
5.2 Easy Controller
The easy remote control is used only in master/slave mode. By connecting to the 1/4” microphone jack of
the first unit, you will find that the remote control on the first unit will control all the other units for Stand by,
Strobe/Next and Fast/Slow function.
1.
STAND BY
: To blackout all the unit.
2.
STROBE/NEXT
: Under FAST mode, the light will strobe in three
different ways:
a.) Strobe in different gobos and colors.
b.) Synchronous strobe in white color.
c.) Two-light strobe in white color.
If the unit in slow mode, press NEXT button to choose desired color
and gobo. It will change ten colors and then change one gobo.
3.
FAST/SLOW
: When the LED is off, it is in FAST mode. The unit’s movement- Pan/Tilt &
Gobo/Color is sound activated. If the LED on, it is in SLOW mode, Pan/Tilt is sound activated
but Gobo/Color wheel are static, controlled by Next button.
In case of replacement of the lamp or maintenance, do not open the
fixture within 15 minutes until the unit cools down after switching off.
