2
1. Safety Instruction
WARNING
l
Please keep this User Guide for future consultation. If you sell the unit to another user, be sure that they
also receive this instruction booklet
l
Unpack and check carefully there is no transportation damage before using the unit.
l
Before operating, ensure that the voltage and frequency of power supply match the power requirements of
the unit.
l
The unit is designed for use with the NSD 15OW or HTI 150W. Do not use any other type of lamp.
l
It’s important to ground the yellow/green conductor to earth in order to avoid electric shock.
l
The unit is for indoor use only. Use only in a dry location.
l
The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent surfaces. Be
sure that no ventilation slots are blocked.
l
l
Disconnect main power before fuse/lamp replacement or servicing.
l
Replace fuse/lamp only with the same type.
l
Make sure there is no flammable materials close to the unit while operating as it is fire hazard.
l
Use safety chain when fixes this unit. Don’t handle the unit by taking its head only, but always by taking its
base.
l
Maximum ambient temperature is TA: 40
_
. Don’t operate it at where the temperature is higher than this.
l
Unit surface temperature may reach up to 85C. Don’t touch the housing bare-hand during its operation, and
allow about 15 minutes to cool down before replacing bulb or serving, as the unit could be very hot.
l
In the event of serious operating problem, stop using the unit immediately. Never try to repair the unit by
yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the
nearest authorized technical assistance center. Always use the same type spare parts.
l
Don’t connect the device to any dimmer pack.
l
Do not touch any wire during operation as high voltage might be causing
electric shock.
.
G. If The pan belt is broken
1. Turn off the main power.
2. Unscrew all the screws (A) and open the base-housing cover (B).
3. Unplug all the connect wires (C) that from the arm to PC board and ignitor.
4. Unscrew the screws (D) that fix the axis gear (E).
5. Change a new belt (F) by going through all connect wires that from the arm to base, and
through the bridge for correct position.
6. Set up the gear axis to the bridge and screwed it. Note : do not press the belt.
7. Put the belt around the axis gear and motor gear.
8. Plug all the connect wires (C) that form the arm to PC board and ignitor.
9. Adjust the pan home position.
10. Screw the base-housing cover (B).
Please read carefully the instruction, which includes important
information about the installation, usage and maintenance.
