Page 5 of 40
COLORado PXL Bar 16 User Manual Rev. 1
Setup
3. Setup
AC Power
Each COLORado PXL Bar 16 has an auto-ranging power supply that works with an input voltage range of
100 to 240 VAC, 50/60 Hz. To determine the power requirements for each COLORado PXL Bar 16, refer to
the label affixed to the product. You can also refer to the Technical Specifications chart in this manual.
The listed current rating indicates the maximum current draw during normal operation. For more
information, download Sizing Circuit Breakers from the Chauvet website:
AC Plug
The COLORado PXL Bar 16 comes with a power input cord terminated with a Seetronic Powerkon A
connector on one end and an Edison plug on the other end (U.S. market). If the power input cord that
came with your product has no plug, or if you need the change the plug, use the table below to wire the
new plug.
Power Linking
The product supports power linking. You can power link up to 3 products at 208 V, 230 V, and 240 V.
This product comes with a power input cord. Power-linking cables are available from Chauvet for purchase.
DMX Linking
You can link the COLORado PXL Bar 16 to a DMX controller using a 5-pin DMX connection. If using other
DMX-compatible products with this product, you can control each individually with a single DMX controller.
DMX Personalities
The COLORado PXL Bar 16 uses DMX, Art-Net™, sACN, and Kling-Net for its control personalities:
Remote Device Management (RDM)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate
bi-directionally along existing DMX cabling. Check the DMX controller’s User Manual or with the
manufacturer as not all DMX controllers have this capability. The COLORado PXL Bar 16 supports RDM
protocol that allows feedback to make changes to menu map options.
• Always connect the product to a protected circuit (a circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or fire.
• To eliminate unnecessary wear and improve its lifespan, during periods of non-use
completely disconnect the product from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
Connection
Wire (U.S.)
Wire (Europe)
Screw Color
AC Live
Black
Brown
Yellow or Brass
AC Neutral
White
Blue
Silver
AC Ground
Green/Yellow
Green/Yellow
Green
• To preserve the IP65 rating and the warranty of this product, Seetronic Powerkon cables
must be used.
• Insert the attached IP65-rated plugs into the corresponding power/data connections
when not in use.
Single Mode
Dual Mode Movement
Dual Mode Pixels
Basic
(20 channels)
Basic
(8 channels)
Basic
(48 channels)
Standard
(84 channels)
Standard
(20 channels)
Standard
(64 channels)
Advanced
(154 channels)
Advanced
(26 channels)
Advanced
(128 channels)
Tour
(186 channels)
Basic2
(7 channels)
Uses DMX, Art-Net™, sACN, or
Kling-Net
Basic2
(19 channels)
Uses DMX, Art-Net™, or sACN
Uses DMX, Art-Net™, or sACN
If you are not familiar with or need more information about DMX standards, Master/Slave
connectivity, or the DMX cables needed to link this product to a DMX controller, download
the DMX Primer from the Chauvet website: